Image Analysis for Evaluating Air Void Parameters of Concrete, HR-396, 1998

(1998) Image Analysis for Evaluating Air Void Parameters of Concrete, HR-396, 1998. Transportation, Department of

[img]
Preview
PDF
IADOT_hr396_Image_Analysis_Evaluating_Air_Void_Parameters_Concrete_1998.pdf

File Size:2MB

Abstract

This research project investigated the use of image analysis to measure the air void parameters of concrete specimens produced under standard laboratory conditions. The results obtained from the image analysis technique were compared to results obtained from plastic air content tests, Danish air meter tests (also referred to as Air Void Analyzer tests), high-pressure air content tests on hardened concrete, and linear traverse tests (as per ASTM C-457). Hardened concrete specimens were sent to three different laboratories for the linear traverse tests. The samples that were circulated to the three labs consisted of specimens that needed different levels of surface preparation. The first set consisted of approximately 18 specimens that had been sectioned from a 4 in. by 4 in. by 18 in. (10 cm by 10 cm by 46 cm) beam using a saw equipped with a diamond blade. These specimens were subjected to the normal sample preparation techniques that were commonly employed by the three different labs (each lab practiced slightly different specimen preparation techniques). The second set of samples consisted of eight specimens that had been ground and polished at a single laboratory. The companion labs were only supposed to retouch the sample surfaces if they exhibited major flaws. In general, the study indicated that the image analysis test results for entrained air content exhibited good to strong correlation to the average values determined via the linear traverse technique. Specimens ground and polished in a single laboratory and then circulated to the other participating laboratories for the air content determinations exhibited the strongest correlation between the image analysis and linear traverse techniques (coefficient of determination, r-squared = 0.96, for n=8). Specimens ground and polished at each of the individual laboratories exhibited considerably more scatter (coefficient of determination, r-squared = 0.78, for n=16). The image analysis technique tended to produce low estimates of the specific surface of the voids when compared to the results from the linear traverse method. This caused the image analysis spacing factor calculations to produce larger values than those obtained from the linear traverse tests. The image analysis spacing factors were still successful at distinguishing between the frost-prone test specimens and the other (more durable) test specimens that were studied in this research project.

Item Type: Departmental Report
Keywords: Air voids, Alternatives analysis, Concrete hardening, Image analysis, Image processing, Specimens, Test procedures
Subjects: Transportation
Transportation > Materials
Transportation > Roads and highways
Transportation > Research
Transportation > Research > Concrete
ID Code: 17078
Deposited By: Iowa DOT Library
Deposited On: 04 Jun 2014 19:30
Last Modified: 15 Jan 2015 16:14
URI: https://publications.iowa.gov/id/eprint/17078